Lenovo Converged HX Series Installation And Service Manual page 174

Message:
12V voltage is too low
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010B10
Full Sensor Name (Sensor Name In SDR):
SYS_12V
Sensor Type:
Voltage
Event Severity:
Critical
Description:
Upper Non-Recoverable - Going High - Asserted
Message:
12V voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010910
Full Sensor Name (Sensor Name In SDR):
SYS_12V
Sensor Type:
Voltage
Event Severity:
Critical
Description:
Upper Critical - Going High - Asserted
Message:
12V voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010710
Full Sensor Name (Sensor Name In SDR):
160
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide