Lenovo Converged HX Series Installation And Service Manual page 114

DIMM F2
DIMM F1
DIMM E2
DIMM E1
DIMM A1
DIMM A2
DIMM B1
DIMM B2
Figure 33. The location of the DIMM connectors on the system board
The following sections provide additional information specific to registered DIMMs that you must consider.
Installing a DIMM
Use this information to install a DIMM.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
If you are replacing a server component or installing an optional device in the server, you need to take out the
node out from the rack enclosure, turn off the server and peripheral devices, and disconnect all external
cables.
Attention: Static electricity that is released to internal server components when the server is powered on
might cause the server to halt, which might result in the loss of data. To avoid this potential problem, always
use an electrostatic-discharge wrist strap or other grounding system when you work inside the server with
the power on.
The following illustration shows the location of the DIMM connectors on the system board.
100
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
DIMM H2
DIMM H1
DIMM G2
DIMM G1
Microprocessor 2
Microprocessor 1
DIMM C1
DIMM C2
DIMM D1
DIMM D2