Lenovo Converged HX Series Installation And Service Manual page 175

SYS_12V
Sensor Type:
Voltage
Event Severity:
Warning
Description:
Upper Non-Critical - Going High - Asserted
Message:
12V voltage is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010411
Full Sensor Name (Sensor Name In SDR):
SYS_5V
Sensor Type:
Voltage
Event Severity:
Critical
Description:
Lower Non-Recoverable - Going Low - Asserted
Message:
5V voltage is too low
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. If the error recurs, contact Lenovo service representative for execution of node replacement.
• Diagnostic Code:
02010211
Full Sensor Name (Sensor Name In SDR):
SYS_5V
Sensor Type:
Voltage
Event Severity:
Critical
Description:
Lower Critical - Going Low - Asserted
Message:
5V voltage is too low
Appendix A. TMM error messages
161