Lenovo Converged HX Series Installation And Service Manual page 34

2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
3. If there is a clear protective sticker on the switch blocks, you must remove and discard it to access the
switches.
SATADOM power jumper
(JP136)
Clear CMOS jumper
Figure 11. Location of the switches, jumpers, and buttons on the system board
The following table describes the jumpers on the system board.
20
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
4
3
2
1
3
2
1
Switch block 1 (SW1)
8
7
6
5
4
3
2
1
ON