Nortel Meridian Mail User Manual page 34

Getting Started
2. Select a currently unassigned data port (follow bulleted instructions
below) set to PRTnnnn, and change it to ADMIN for AdminPlus.
¥ To select a dataport for AdminPlus on an MMP40 card
For NT6P97AA Release 10 (EC platforms) of the MMP40 card, select Port
2. Choosing the second port prevents an interworking problem between
Port 1 and the AdminPlus link. For a later vintage of MMP40, select either
Port 1 or 2.
¥ To select a dataport for AdminPlus on a Mod Op EC system
For Mod Op EC systems on MM10.07, select only Port 2, 3, or 4 of a Utility
Card with Modem (NT6P03AA A0391972). For systems on MM10.10 or
later, select Port 1, 2, 3, or 4.
Note: You cannot conÞgure the AdminPlus link on the second Utility card of
a Mod Op EC system.
The selected dataport appears as ADMNnnnn in the hardware database.
Procedure 2-2
To assign a data port for the AdminPlus Enable option under Meridian
Mail 11
Select a currently unassigned data port (follow bulleted instructions below)
set to PRTnnnn, and change it to ADMIN for AdminPlus.
¥ To select a dataport for AdminPlus on an MMP40 card
For NT6P97AA Release 10 (EC platforms) of the MMP40 card, select Port
2. Choosing the second port prevents an interworking problem between
Port 1 and the AdminPlus link. For a later vintage of MMP40, select either
Port 1 or 2.
¥ To select a dataport for AdminPlus on a Mod Op EC system
Select any port on the Þrst Utility card. You cannot conÞgure the AdminPlus
link on the second Utility card.
The selected dataport appears as ADMNnnnn in the hardware database.
2 - 11