.
Ethernet module configuration using
the CLI
Configure an Ethernet port to ensure proper operation and optimum port
performance.
Navigation
•
"Roadmap of port CLI commands" (page 31)
•
"Job aid: Port-related configuration parameters" (page 35)
•
"Disabling a module" (page 37)
•
"Configuring 10/100/1000 Mbit/s ports" (page 37)
•
"Configuring 1 Gigabit Ethernet ports" (page 39)
•
"Configuring 10 Gigabit Ethernet ports" (page 40)
•
"Associating a port to a VRF instance" (page 42)
•
"Configuring high-priority control MAC addresses for the 8648GTR
module" (page 43)
Roadmap of port CLI commands
The following table lists some of the config ethernet <slot/port>
commands and parameters that you can use to perform the procedures in
this chapter.
Nortel Ethernet Routing Switch 8600
Configuration — Ethernet Modules
NN46205-503 04.01 21 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
31