Configuring Aur Using The Cli - Nortel 4500 Series Overview-System Configuration

128 About the Nortel Ethernet Routing Switch 4500 Series
CFG mirror images in the stack after adding unit 5
Synchronizing the CFG mirror images with CFG images
A CFG mirror image is updated whenever a CFG flash drive synchronization
occurs in the AU.
Configuring AUR using the CLI
This section describes the CLI commands used in AUR configuration.
show stack auto-unit-replacement command
The show stack auto-unit-replacement command displays the
current AUR settings.
The syntax for this command is
show stack auto-unit-replacement
The stack auto-unit-replacement enable command is in all
command modes.
No parameters or variables are available for the show stack auto-unit
replacement command.
Copyright © 2007, Nortel Networks
.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Nortel Networks Confidential