Settings For Dialing; Changing The Dialing Pause Length; Changing Redial Settings - Muratec MFX-1200 Operating Instructions Manual

Settings for dialing

Changing the dialing pause length

Default setting: 2 seconds.
The pause is set by the factory to last two seconds, but you can set it to last as long
as ten seconds if necessary. To change the pause length:
1
Press Program key, , 2, 0, 5,
B
Dialing Pause
Ti m e ( 0 2 - 1 0 ) :02
2
Use the numeric keypad to enter the length you want for the dialing pause.
Here, we ve chosen nine seconds.
Dialing Pause
Ti m e ( 0 2 - 1 0 ) :09
Note: The length setting requires two digits. Always enter a leading zero for
lengths less than 10 seconds.
3
Press to save the setting.
ENTER
.
ENTER

Changing redial settings

Default setting: Number of redial: 2 times, Redial interval: 1 minute.
It s up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval).
To program the redial settings:
1
Press Program key, , 2, 0, 4,
B
# Of Redials
# ( 0 2 - 1 5 ) :02
2
Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 15 redials. In this example, we ve entered 03.
# Of Redials
# ( 0 2 - 1 5 ) :03
Note: Enter a leading zero when entering a quantity less than 10.
3
Press to save the setting.
ENTER
4
The now shows:
LCD
Redial Interval
I n t e r v a l ( 1 - 5 ) :1
5
Use the numeric keypad to enter the length you want between redial
attempts. Choose from 1 to 5 minutes. In this example, we ve chosen 4.
Redial Interval
I n t e r v a l ( 1 - 5 ) :4
6
Press to save the setting.
ENTER
Changing the default settings
.
ENTER
4.5