Muratec MFX-1200 Operating Instructions Manual page 106

Important: While in Mode 1, any autodialer numbers you use must include
PIN
the . This also applies to autodialer numbers used with batch
PIN
transmission (see page 3.12) or programmable one-touch keys (see
pages 3.36 3.49).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission,
you must store the access code for the remote unit within the appropri-
PIN
ate batch box.
If you chose Mode 2 as you autodial, load the code
In this mode, you don t have to add the
enter the manually each time you autodial:
PIN
1
Dial the number as you normally would, using the autodialer. Here, we ve
pushed one-touch key . The machine now asks for the
A
Enter PIN Number
_
2
Use the numeric keypad to enter the
Enter PIN Number
1057_
3
Press . Your machine dials the number.
START
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see page 3.12), you must store the
within the appropriate batch box.
Dialing from the numeric keypad while using the
If you ve specified Mode 1 use star power
1
Enter the phone number, then press the * ( star ) key and enter the
The always goes last. For example, to dial 19725550911 with a
PIN
123456 , enter 19725550911*123456:
Press Start
19725550911*123456_
2
Press . The disappears from the display, and your machine dials the
START PIN
desired phone number.
to the autodialer setting. Instead, you
PIN
:
PIN
.
PIN
access code for the remote unit
PIN
mask
PIN
PIN
PIN
If you ve specified Mode 2 the machine guides you
1
Enter the phone number as usual.
Press Start
19725550911_
2
Press . The
START
Enter PIN Number
_
3
Use the numeric keypad to enter the
Enter PIN Number
123456_
4
Press . Your machine dials the number.
START
Performing batch transmission while using the
Note: The following instructions presume you are familiar with how to set and use
both your machine s autodialer and its batch transmission feature. If you
need to review, see pages 3.1 3.9 for more on the autodialer and/or page 3.12
for more on batch transmission.
If you ve specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include
the
PIN
number, review the Mode 1 instructions under Autodialing while
using the
Before sending a batch transmission the first time, you must store the
batch box. Here s how:
1
Follow the steps for creating or modifying a batch box (pages 3.12 3.13).
.
The asks for the fax number (here, we re working with batch box 1):
LCD
of
1:Fax Number
_
2
Enter an autodialer number, or use the numeric keypad to enter the fax num-
ber, to which the batch transmission should go.
Important: If you re entering a number from the numeric keypad, enter the
shows:
LCD
.
PIN
. (To review how to include this information in an autodialer
mask, page 3.52.)
PIN
fax number, followed by the * ( star ) key and then the
Advanced features
mask
PIN
within its
PIN
.
PIN
3.53