Muratec MFX-1200 Operating Instructions Manual page 91

Advanced features
17
Press . The asks you for the type of confirmation report you want to
ENTER LCD
set for this programmable one-touch number.
R e p o r t : - - -
← ← / → → /Enter
18
Press until the mode you want appears.
19
Press . The asks if you want to send a cover page for this program-
ENTER LCD
mable one-touch number.
Cover Page :---
← ← / → → /Enter
20
Press until the mode you want appears.
21
Press . The asks if you want to turn the Fax & Copy feature on or
ENTER LCD
off for this programmable one-touch number.
Fax & Copy :---
← ← / → → /Enter
Note: When the memory transmission is set to off in step 15, this
not appear and go to step 24.
22
Press until the mode you want appears.
23
Press .
ENTER
24
Press to return your machine to standby mode.
STOP
3.38
Programming a broadcast / group
Programming a broadcast is very similar to programming a delayed transmission.
But instead of sending to just one phone number, you set up multiple numbers for
the transmission.
To program a broadcast / group into a programmable one-touch key:
1
Press Program key,
grammable one-touch number available:
Select Program No.
P2:No Number Stored
Note: If P2 appears on the
number for P1. You can see what you programmed into P1 by press-
ing , if you want. For example, if you set P1 for storing of the polling
document, you will see:
Select Program No.
P1:Polling Document
Press
enter.
will
LCD
Note: To erase a programmable one-touch key, see page 3.49.
2
Press the key that you want to program or change. Here, we ve selected P2.
Select Program No.
P2:No Number Stored
Note: If you re changing a previously stored command: If your previous com-
mand for this key was a for a broadcast/group transmission, and you
want to keep this key programmed for a broadcast/group transmis-
sion, use these instructions to make changes. But if you want to
assign this key to a completely different operation for batch transmis-
sion, then you must first erase the stored command before
programming the new one.
3
If you want to select a different programmable one-touch key than what
appears on the
4
Press
ENTER
grammable one-touch:
Type :Communication
← ← / → → /Enter
Note: If changing a previously stored command, skip to step 7.
, 3, 0, 1, . The shows the first empty pro-
A ENTER LCD
, it means that you have already entered a
LCD
to go back to the programmable one-touch key you want to
, press that key now.
LCD
. The asks which operation you want to program into the pro-
LCD