Using The Bypass Tray; Memory Overflow Message; If The Paper Runs Out While Copying - Muratec MFX-1200 Operating Instructions Manual

Basic operation

Using the bypass tray

When you need to use a size of paper not currently loaded in your machine s paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
Important: If loading transparency (OHP) film into the bypass tray, be sure that
the sheet is designed for laser printers and not for copiers. Also, be
sure that the film does not have a paper backing and/or a leading
strip. If it does, remove the paper backing and/or strip before insert-
ing. Only film should go in, not film with any backing or strip.
1
Either insert the document in the
2
Set the paper in the bypass tray.
See the table of Acceptable paper size and cassette capacity on page 1.8 and
Loading paper in bypass tray on page 1.10 for more information.
Note: Place the original document in the same orientation as the paper in
the paper source (which you ll select in step 5, below).
3
Press to select the bypass tray until the
PAPER SIZE
light of the bypass tray of the printer status lights on
the control panel glows.
4
If necessary, select desired resolution, contrast,
reduction/enlargement ratio.
5
Press to begin the copying process.
START

Memory overflow message

If you ve stored too much information in your machine s memory, a Memory
Overflow message may appear on the
Memory Overflow
Start Or Cancel
This appears because (1) too many pages have been stored in the memory, or (2)
the pages that are stored have too much information on them for your fax machine
to remember.
If this message appears, press
START
memory, or press to delete from memory all pages stored during the current
CANCEL
operation (but not previous operations).
Note: If you don t operate your machine within 60 seconds, the machine will auto-
matically print the document stored in the memory during the current
operation.
2.14
or place it on the glass.
ADF FBS
:
LCD
to tell your machine to copy as many pages in

If the paper runs out while copying

When your machine runs out of paper, it beeps, the red light
of the printer status lights glows and the
source has run out of paper the 1st cassette, 2nd cassette
(optional) or the bypass tray.
In this example, the machine runs out of the paper in the 1st
cassette:
1st Cassette
Please Supply Paper
If you want to cancel the current copying job, press
paper to displayed paper source to resume the copying.
shows which
LCD
. Otherwise, supply the
STOP