Convert Dialing Characters In E-Mail Gateway Functions - Muratec F-315 Field Engineering Manual

3.32 Convert dialing characters in e–mail gateway
functions
Note: This function is available only when the optional network board has been installed.
When transmitting on e-mail gateway, the following dialing characters will be converted to certain
characters specified here:
Pause (/P)
Tone (/T)
Flash (/F)
1. Start the web browser on a network computer.
2. Type the machine's IP address in the URL address field followed by "/dialoption.htm" (slash dialoption
dot htm).
For example; http://192.168.1.10/dialoption.htm
3. Enter the characters to which the machine should convert the dialing character.
4. Click "Save" to save the setting.
Note:
"Tone" is for USA model only.
Up to two characters are able to enter for each dialing character.
For available characters, see table below.
If the box is blank, the dialing characters will be override when transmitting over the e–mail
gateway.
3-159