Muratec MFX-1200 Operating Instructions Manual page 145

Just in case
Redialing The dialing again, either manually or automatically controlled, of the most
recently dialed fax or phone number. Automatic redialing follows an unsuccessful dialing
attempt and can be done manually or automatically.
Relay broadcasting Lets some Muratec fax machines store a document in internal mem-
ory, transmit the document to the memory of a remote hub fax and then instruct that unit
to relay (re-transmit) the document to each fax in a call group in the hub unit. This feature
speeds extremely high-volume fax communication and allows a single command to initiate
document transmission to hundreds of preprogrammed fax locations. It also saves phone
charges for the originating machine. Your machine can initiate a relay broadcast.
Remote fax machine The machine on the other end of a fax communication.
S e e Ringer equivalence number.
REN
Resolution The resolution of documents transmitted or copied by fax machines is mea-
sured by the number of horizontal (
Muratec unit may offer one or more of these resolution levels:
Normal 203 98 lpi
H V
Fine 203 196 lpi
H V
Superfine 203 392 lpi
H V
Some Muratec units also offer grayscale transmission (see also Grayscale) for accurate repro-
duction of photographs and other shaded originals.
Ringer equivalence number
equipment used in the United States; designed to prevent overloading on a telephone circuit.
See also Load number.
Scanning width S e e Effective scanning width.
SecureMail Allows a Muratec fax user to send a document to or receive one into (usually
something confidential) an electronic mail box. The transmission is protected at the receiv-
ing Muratec fax by an access code; the receiving fax prints the document only when an
authorized user enters the code.
Secure polling Polling in which preset passcodes are checked between two machines
before polling is allowed to take place.
Speed-dialing Allows the fax user to store frequently used fax numbers for dialing with
the touch of three keys an identifier key (either * or #) and then a three-digit code for
each number. See also Autodialing and One-touch dialing.
Station (Also called Location
ID
user enter a descriptive name to correspond with the number in an autodialer entry. For
example, rather than entering only 1-972-555-3465, the user can enter that number and a
name, such as Dallas Branch Office. (Many Muratec models with this feature allow entry of
both upper-case and lower-case letters, for greater ease of reading.)
Subaddressing An ITU-T standard allowing fax machines to specify special delivery
characteristics of a transmission. For example, subaddressing allows fax machines from dif-
ferent manufacturers to send and receive messages into confidential memory mailboxes, or to
retrieve specific files from polling memory.
Subscriber A fax machine s telephone number, as identified by a user setting. See
ID
5.20
) and vertical ( ) lines per inch (lpi) the unit can print. A
H V
Also called . A number assigned to telecommunications
REN
or Receiver .) An autodialer feature which lets the fax
ID ID
Super Group 3 An extension of Group 3 fax technology standards, allowing the use of
high-speed v.34 bis modems for 33.6 Kbps transmission and high-speed protocols for rapid
handshaking.
Superfine resolution 2 0 3
sion mode is Group-3-compatible, not the more limited proprietary version.
Telephone answering device, or answering machine. Records incoming voice messages
TAD
for playback. You can connect a
line.
Transmit confirmation report; this provides proof that your Muratec fax did send the
TCR
document you set for transmission. Printed after transmission, the
telephone number to which the fax sent the document, plus the actual time of transmission
and how many pages the unit transmitted. See also
Thermal (paper) printing
paper in patterns conforming to the image the machine has scanned, creating a printed
image. Thermal paper s tendency to discolor and fade, in addition to its curliness and the
usual difficulty in writing on it, have made this method considerably less popular than plain-
paper fax printing particularly as plain-paper fax machines have dropped sharply in price.
TriAccess Muratec s TriAccess allows a Muratec fax machine to perform three or more
tasks simultaneously without slowing.
Transmit terminal identifier. A user-programmable line of information sent automati-
TTI
cally with every page a fax machine sends; it appears at the top of each page printed by the
receiving unit.
Transmission speed How fast a fax machine is sending a fax document. This speed
depends upon the modem speed of each unit, the resolution setting, the content of the docu-
ment, the encoding technique and the condition of the phone line (clean, noisy, etc.) Any
change in any one of these five conditions will affect the speed, sometimes significantly.
.29 and v.27 ter A standard set of communication procedures allowing fax machines to
V
talk to other units using those standards. Specifically, these standards cover fax transmission
at 9600 bps or slower.
.34 An international standard for fax modems and other modems with transmission
V
speeds of up to 28.8 Kbps. The
represented a significant increase in possible transmission speed compared to the transmis-
sion protocol it replaced.
.34 bis A faster version of the
V
.34 + . The .34 bis protocol allows transmission at up to 33.6 Kbps, and represents the cur-
V V
rent maximum standard transmission speed possible under ITU-T Group 3. (The term bis is
French, and designates the second version of the protocol.)
White-line skip A technique used to speed up fax transmission by bypassing redundant
areas, such as white space.
.
TTI
392 lpi. Your Muratec fax machine s superfine transmis-
H V
to a Muratec fax machine and use the two on one phone
TAD
TCR
.
RCR
A thermal head heats chemically treated, thermally sensitive
.34 protocol is sometimes referred to as
V
.34 standard, and sometimes referred to as
V
also identifies the
.Fast , because it
V
.34 Plus or
V