Without T.h - Titan TTS2 Manual

[ESC]:to quit REM measurement.
You can choice according to the actual usage.

9.4.1.2 "Without T.H"

After select this mode, enter the interface of "REM-Prism":
Aim at the prism, then press [Meas] to measure the horizontal
distance from prism to prism and enter the interface of "REM-Base";
Aim at the reference point and press [Select] to enter the dialog
of 'REM-Altitude'
Then turn the telescope up and down. The elevation difference
between the target and the reference point is displayed in the VD
column.
After the measurement, you have three opts:
[Set VA] :to re-enter the 'REM-Altitude' page.
[HDist] :to re-measure the horizontal distance;
[ESC]:to quit REM measurement.
80