Import; Import From Pc - Titan TTS2 Manual

Table of Contents

Pressing [▼] can display the information of the next piece



data;

●Press [Search] to enter the condition input interface, and you

can input the point name which you want and press [Enter] ,then the

system searches the data from the first piece (all name matched). If

searching it, the cursor will be at the point , or will tip and back to the

first piece data.

●press [Del] to enter the interface of "Del",if select [Yes], the

data you selected will be deleted or press [Exit] back to the data list.

9.3.2 Import

As the format of file in the instrument is binary, the External

data must be imported to instrument. This function can import the

external ASCII coordinate file and code file to instrument to save in

binary format. The types of file you selected are distinguished each

other by extension. So, you must be careful about the file type, or you

will import unsuccessfully.

The interface of importing file as shown in picture below:

This function needs port to connect PC and instrument, but the

transfer software must be installed on the PC to end data, or the

instrument can' receive. Press [Fileman]→ [2](Import)→ [1.Import

from PC],then the interface of "Import data" as shown below:

AS an example of receiving coordinate data, press [1] to enter

the interface of "Select file(.COO)";

Table of Contents