7. Coordinate mode
Press [CORD] to enter the coordinate measurement mode.
According to the diagram below, please set up the coordinates station,
azimuth, target height and instrument height before coordinate
measurement.
There are three interfaces, which can be switched each other by
pressing [F4].The functions of the first interface are "Save", "Meas",
"Mode"; The functions of the second interface are "Config", "BSS",
"STA"; The functions of the third interface are "Offset", "S.O",
"Aver.". as shown in picture belown
Save: After pressing [F1], whether recorsing after the
●
completion
"Information" appears after pressing [Yes] (if you haven't
of
measuring
42
point
,the
interface
of