Table of Contents
Advertisement
current settings will be saved in the measurement file;
9.1.4Measurement
1) In the first page of surveying, press [3] to enter the interface of
"Meas";
2) Press [F1](Input) to input the measurement point name ,then
press [Enter] to input code;
3) Input target height (I.H) ,then press [Enter];
4) Press [F3](Meas), here,there are four methods for you to select,
which are "Angle", "Dist" , "Coord.", "Offset", as shown in
picture below:
5) Aim at the target height, press one of the key "[F1]~[F3]". For
example, press [F2](Dist) to start measuring;
58
Advertisement
Table of Contents
