Import From Usb - Titan TTS2 Manual

You can input the file name used to save the received data, such
as "123"(.COO). If the file exists in the instrument, prompts "File
Exist". If selecting [List], you can select a file in FLASH disk. After
selecting file, press [Enter] to enter the interface of importing;
The only column that can be set is the Baud. The Baud available
are 2400, 4800, 9600, 19200, 38400, 57600, 115200 with respect to
the RS232C serial communication bus. The bauds can be set with soft
keys [Fast] and [Slow]. Usually, 115200 Baud is adequate for
importing.
Import: Import data. The process of importing requires
assistance of the connected computer. Firstly, the data must be
imported to the computer already and waited to be received by
instrument. Then press softy key [Import] to import the data. After a
success import, the coordinates will appear at the bottom of the
selected file, while the number "NO." is refreshing until the
importing is finished.

9.3.2.2 Import from USB

Firstly, you must insert the Udisk to instrument. The instrument
will read the text files (.TXT) in the 'PROJECT' folder in the Udisk.
You must make sure that the imported files must be in the
'PROJECT' file, and the file name must be letters, numbers or
together. Or, the file name can't be displayed normally.
Enter the importing interface, as shown in the picture below:
71