Explanation Of Saving Data; Star Key [★] Mode - Titan TTS2 Manual

2.3.4 Explanation of saving data

If you have never selected the measurement file and your first
time to use the [Save] soft key, a dialogue box of 'Select file' would
appear to the screen. Mention that this is a good chance for you to
select all files that the instrument may use.
When finishing single measurement, a dialogue box asks you to
save the measured point and you may rename and code the points or
set target height. The key 'ENT' will save the coordinates into
measurement files, and the key [ ★ ] save the coordinates in the
measurement file and coordinate file at the same time (according to
the mention of the display).
If you choose not to edit points, the points would be saved with
the present name, elevation and code .After saving, the name of the
point is added by one.
2.4 Star key [★] mode
On the measurement interfaces, pressing the key [★](star key)
can lead to a page as shown below.
Settings from the star key(★) are as followed:
EDM Mode : press [±] to set the work mode of EDM. These
●
modes are "Single" , "Rept" , "Cont" , "Track" .Adjust
contrast : press [▲] and [▼];
Adjust background light of the screen : press [F1] to open
●
the backlight ,then press [◄] to adjust light;
Comp.: press [F2] to enter the display of electric bubble ,
●
then setting the compensator off; pressing [◄] [►] can
adjust the light of laser plumb;
Reflect: Press [►] to set the reflector. The options of
●
reflector are switched between Prism ,Non- prism(NP) and
reflector board(RB);
Laser: press [F3] to on or off the laser;
●
Para.: Press the key [F4] to select 'parameters'. You can set
●
settings of prism const, PPM value and temperature and
20