Titan TTS2 Manual page 77

guidance of professionals, if the operation is wrong, it may lead to
the instrument can't work properly!
This function is for you to upgrade the software of the
instrument. Press [1] on the second page of "Fileman" to enter the
interface of updating, as shown in picture below:
1) Input "PIN" (82543), then press [ENT] with the instrument
shutdown;
2) Connect the instrument to the computer through serial port
connector. Open the hyper terminal softwareand set up the
correct port. Then set 'Bits per second ' to 115200 and
' Flow control ' to ' None '. Finally, when all operations
above are done, press [ENT] to update. Mention that the
computer must be installed with correct drivers;
3) Press power button on the instrument. The page of hyper
terminal is as followed;
Note: you must be specifically cautious when updating. As soon
as you choose to update, the instrument will enter updating mode. If
pressing key '3' under the page shown below, the previous program
may be resumed.
76