Titan TTS2 Manual page 62

4) Input the target height;
5) After setting the stake-out point, you can start to stake out.
HR:The calculated angle of tak-outpoint
HD: the calculated distance from instrument to stake-out point;
Aim at the prism center, then press [F1](Dist) (or [F2](Coord.))
6) The rotation angle of the alidade will be calculated by the
instrument;
HR: measured angle
dHR: the rotation angle (when the instrument aiming at stake-out
point)
When "dHR=0°00'00"", it means you haves found the direction
pf stake-out point.
7) Rotate the instrument to make the "dHR" as about 0°, then
lock the horizontal motion screw and use horizontal tangent
screw to make the "dHR" as "0°00'00"". Finally, press[F1]
(Meas);
HD: Measured distance
dHD: Distance difference when aiming at stake-out point
dN: measured coordinate(N)- coordinate (N) stake-out
dE: measured coordinate(E)- coordinate (E) stake-out
dZ: measured coordinate(Z)- coordinate (Z) stake-out
[Dist]
[Dist]
61
[Coord.]
[Coord.]