Connect Acx7100-32C To External Devices; Connect An Acx7100-32C Router To A Management Console - Juniper ACX7100-32C Hardware Manual

Maintaining the ACX7100-32C Power Supplies | 86

Connect ACX7100-32C to External Devices

IN THIS SECTION

Connect an ACX7100-32C Router to a Management Console | 75

Connect an ACX7100-32C Router to a Network for Out-of-Band Management | 76
Connect an ACX7100-32C Router to External Clocking and Timing Devices | 77
Connect an ACX7100-32C Router to a Management Console
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an RJ-45 to DB-9
adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 pin contact and you want to connect your
laptop or PC directly to the ACX7100-32C router, use a combination of the RJ-45 cable and
RJ-45 to DB-9 adapter supplied with the device and a USB to DB-9 plug adapter. You must
provide the USB to DB-9 plug adapter.
The ACX7100-32C routers have a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
To connect the ACX7100-32C router to a management console (see
32 on page 76):
1. Connect one end of the Ethernet cable to the console port (labeled CON).
Figure 31 on page 76 and Figure
75