Juniper ACX7100-32C Hardware Manual page 18

The management panel on an ACX7100-32C router displays the router product number, and consists of
the following components:
• Status LEDs—ALM, SYS, MST, and ID LEDs.
• Management (MGMT) port—10/100/1000BASE-T management port that uses an RJ-45 connector
to connect to a management device for out-of-band management. See
Router to a Network for Out-of-Band Management" on page
• Console (CON) port—uses an RJ-45 connector to connect to a console management device. An
optional GPS time of day (TOD) device is also supported. To connect to both a console and a TOD
device simultaneously, you must use the breakout cable that is provided with the device.
NOTE: If you connect to both console and ToD simultaneously using a breakout cable, you
must ensure that you have not configured the log-out-on-disconnect statement at the [edit
system ports console] hierarchy level.
• USB port for image updates
• Reset button to reset the device.
• SMB connector ports that support 1-PPS and 10-MHz timing devices.
simultaneously, you must use the breakout
cable that is provided with the device.
"Connect an ACX7100-32C
76.
10