Juniper ACX7100-32C Hardware Manual page 98

7. Observe the status LED on the power supply faceplate. If the PSM is correctly installed and
functioning normally, the status LED lights green steadily.
Figure 37: Install an AC PSM in an ACX7100-32C Router
Figure 38: Install an AC Power Cord in an ACX7100-32C router
NOTE: Each PSM must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade of
hardware components at
updateinstallbase.jsp
parts. This note does not apply if you replace components with the same type of component.
https:/ /www.juniper.net/customers/csc/management/
. Failure to do so can result in significant delays if you need replacement
90