Step 5: Connect External Devices and PIC Cables
Connect a Management Console
Copyright © 2016, Juniper Networks, Inc.
Figure 7: Connect External Devices and PIC Cables
To connect external devices and PIC cables, perform the following procedures:
Connect a Management Console on page 19
Connect to a Network for Out-of-Band Management on page 20
Connect the PIC Cables on page 20
Locate the appropriate cable and connector.
1.
Turn off the power switch on the console.
2.
Plug the female end of the RS-232 serial connector into the
3.
Connector Interface Panel (CIP).
Step 5: Connect External Devices and PIC Cables
CONSOLE
port on the
19