Step 5: Connect External Devices And Pic Cables; Connect A Management Console - Juniper T320 Quick Start Manual

T320 Core Router Quick Start

Step 5: Connect External Devices and PIC Cables

Connect a Management Console

18
Figure 6: Connecting External Devices and PIC Cables
To connect external devices and PIC cables, perform the following procedures:
Connect a Management Console on page 18
Connect to a Network for Out-of-Band Management on page 19
Connect the PIC Cables on page 19
Locate the appropriate cable and connector.
1.
Turn off the console power switch.
2.
Plug the female end of the RS-232 serial connector into the
3.
Connector Interface Panel (CIP).
port on the
CONSOLE
Copyright © 2015, Juniper Networks, Inc.