Cable And Connector Specifications For Acx7100-32C - Juniper ACX7100-32C Hardware Manual

by product—and the tool displays all the transceivers supported on that device—or by category, interface
speed, or type. The list of supported transceivers for the ACX7100-32C is located at
apps.juniper.net/hct/product/.
CAUTION: If you face a problem running a Juniper Networks device that uses a third-
party optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help
you diagnose the source of the problem. Your JTAC engineer might recommend that
you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.

Cable and Connector Specifications for ACX7100-32C

IN THIS SECTION
12-Fiber MPO Connectors | 44
24-Fiber MPO Connectors | 49
CS Connector | 50
LC Duplex Connectors | 50
The transceivers that are supported on the ACX7100-32C device use fiber-optic cables and connectors.
The type of connector and the type of fiber depends on the transceiver type.
You can determine the type of cable and connector required for your specific transceiver by using the
Hardware Compatibility Tool.
CAUTION: To maintain agency approvals, use only a properly constructed, shielded
cable.
NOTE: The terms multifiber push-on (MPO) and multifiber termination push-on (MTP) describe
the same connector type. The rest of this topic uses MPO to mean MPO or MTP.
https:/ /
43