Connect An Acx7100-32C Router To A Network For Out-Of-Band Management - Juniper ACX7100-32C Hardware Manual

2. Connect the other end of the Ethernet cable into the console server (see
management console (see
Figure 31: Connecting the ACX7100-32C Router to a Management Console Through a Console Server
Figure 32: Connecting the ACX7100-32C Router Directly to a Management Console
Connect an ACX7100-32C Router to a Network for Out-of-Band
Management
Ensure that you have an appropriate cable available. See
Planning" on page 42.
You can monitor and manage the ACX7100-32C router by using a dedicated management channel. Use
the management ports to connect the ACX7100-32C router to a network for out-of-band management.
NOTE: You cannot use the management ports to perform the initial configuration of the
ACX7100-32C router. You must configure the management ports before you can successfully
connect to the ACX7100-32C router using these ports. See
Configuration for the ACX7100-32C Routers" on page
To connect an ACX7100-32C router to a network for out-of-band management (see
77):
Figure 32 on page 76).
Figure 31 on page
"ACX7100-32C Network Cable and Transceiver
"Perform Initial Software
78.
76) or
Figure 33 on page
76