3.
Verify that the status LED on the PSM is not lit.
4.
Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the
other end of the strap to the ESD point on the chassis.
5.
Remove the clear plastic cover protecting the terminal studs on the faceplate.
6.
Using a socket screw driver, remove the screw from each of the DC power terminals (see
on page
92).
7.
Remove the cable lugs from the terminals.
8.
Carefully move the power cables out of the way.
9.
Press the latch located on the DC PSM, to release it from the chassis.
10. Pull the PSM straight out of the chassis (see
Figure 39: Disconnect the DC Power Cables
Figure 40: Remove a DC PSM
Figure 40 on page
92).
92
Figure 39