Remove An Acx7100-32C Router From A Rack Or Cabinet - Juniper ACX7100-32C Hardware Manual

4. Disconnect power to the router by performing one of the following tasks:
• AC power supply—If the AC power source outlet has a power switch, set it to the off (O) position.
If the AC power source outlet does not have a power switch, gently pull out the power cord plug
connected to the power source outlet.
• DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to
the off position.
5. Remove the power source cable from the power supply faceplate:
• AC power supply—Remove the power cord from the power supply faceplate by detaching the
power cord retainer and gently pulling out the socket end of the power cord connected to the
power supply faceplate.
• DC power supply—Remove the screws securing the ring lugs attached to the power source cables
to the power supply module (PSM) using the screwdriver, and remove the power source cables
from the PSM. Replace the screws on the terminals and tighten them.
6. Uncable the router before removing it from the rack or cabinet.

Remove an ACX7100-32C Router from a Rack or Cabinet

Before removing your ACX7100-32C router from its rack:
Ensure that you have the following parts and tools available:
• A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack mounting
screws.
If you need to relocate an installed ACX7100-32C router, use the procedure described in this topic.
NOTE: When you remove multiple devices from a rack, remove the device in the top of the rack
first and proceed to remove the rest of the devices from top to bottom.
• Ensure that the rack is stable and secured to the building.
• Ensure that there is enough space to place the removed router in its new location and along the path
to the new location.
General Safety Guidelines and Warnings
• Read
• Use the appropriate power-off sequence to safely power off the device. See
ACX7100-32C Router" on page
.
108.
"Power Off an
110