Juniper ACX7100-32C Hardware Manual page 117

Ensure that you have the following parts and tools available to power off the router:
• An ESD grounding strap
• An external management device such as a PC
• An RJ-45 to DB-9 rollover cable to connect the external management device to the console port
• A Phillips number 2 screwdriver
To power off your ACX7100-32C router:
1. Connect to the router using one of the following methods:
• Connect a management device to the console (CON) port on the router. For instructions about
connecting a management device to the console (CON) port, see
Router to a Management Console" on page
• You can shut down the router from a management device on your out-of-band management
network. For instructions about connecting a management device to the management (MGMT)
port, see "Connect an ACX7100-32C Router to a Network for Out-of-Band Management" on
page 76.
2. Shut down Junos OS from the external management device by issuing the request system halt
operational mode CLI command. This command shuts down the router gracefully and preserves
system state information. A message appears on the console, confirming that the operating system
has halted.
user@host> request system halt
All nodes will halt, do you wish to continue ? [yes,no] (no) yes
You see the following output (or something similar, depending on the hardware being shut down)
after entering the command:
System going down IMMEDIATELY
*** System shutdown message from user@host ***
halt the system at Tue Feb 16 16:40:55 2021
3. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
"Connect an ACX7100-32C
75.
109