Shaft Seals, Rear Final Drive 0Bn And 0Bp, Removing And Installing; General Information; Left Flange Shaft Seal, Removing And Installing - Audi Q7 2007 Repair Manual

Transfer Case 0BU, Front Final Drive 0BM, 0C1 and 0BN, Rear Final Drive 0BP - Edition 12.2012
4 Shaft Seals, Rear Final Drive 0BN
and 0BP, Removing and Installing
⇒ "4.1 General Information", page 43
⇒ "4.2 Left Flange Shaft Seal, Removing and Installing",
page 43
⇒ "4.3 Right Flange Shaft Seal, Replacing", page 44
⇒ "4.4 Flange Shaft and Driveshaft Seal on Rear Final Drive, Final
Drive Removed, Removing and Installing", page 45
4.1

General Information

• Rear final drive designation and allocation. Refer to
⇒ "4 Rear Final Drive Designation 0BN and 0BP", page 5
4.2 Left Flange Shaft Seal, Removing and
Installing
Special tools and workshop equipment required
♦ Slide Hammer Set - VW 771-
♦ Slide Hammer Set - Hook - VW 771/37-
♦ Rear final drive 0BN - Seal Installer - Flange Shaft - T10256-
♦ Rear final drive 0BP - Seal Installer - Flange Shaft LH -
T10434-
♦ Sealing Grease - G 052 128 A1-
Removing
– Remove left rear drive axle. Refer to ⇒ Rep. Gr. 42 .
– Remove the flange shaft seal using Slide Hammer Set - VW
771- and Slide Hammer Set - Hook - VW 771/37- .
Installing - Rear Final Drive 0BN
– Coat outer edge of the seal with axle oil.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Drive on in new shaft seal as far as stop.
with respect to the correctness of information in this document. Copyright by AUDI AG.
.

4. Shaft Seals, Rear Final Drive 0BN and 0BP, Removing and Installing

Audi Q7 2007 ➤
43