Operating Manual Release For Selector Mechanism - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
5 - 8 Nm
6 - 3.5 Nm
7 - Operating cable for manual release
❑ Removing and installing
❑ Different versions (according to model) ⇒ Electronic parts catalogue
8 - Electrical connector
❑ For selector lever lock solenoid -N110- and switch for gear selector position P -F305-
9 - Shift unit
❑ With selector lever lock solenoid -N110- and switch for gear selector position P -F305-
❑ Can only be renewed as a complete unit
❑ Different versions (according to model) ⇒ Electronic parts catalogue
❑ Removing and installing
10 - 8 Nm
11 - Cover for shift unit
❑ With glued-on gasket
12 - Noise insulation
13 - Securing clip
❑ For securing noise insulation to selector mechanism
❑ Renew
14 - 1.5 Nm
4.6 Operating manual release for selector
mechanism
Note
If the battery is disconnected or discharged, the selector lever
♦
cannot be shifted from position "P".
When you operate the manual release mechanism the selec‐
♦
tor lever lock solenoid -N110- will release the lock without
current supply.
Procedure
– Take out insert -1- for front ashtray by pressing button
-arrow-.
20
Rep. Gr.37 - Controls, housing
⇒ page 21
⇒ page 21
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.