[Pr. Pt34_Positioning Operation Data Default (**Pdef)]; [Pr. Pt38_Function Selection T-7 (**Top7)] - Mitsubishi Electric MR-J5-G User Manual

[Pr. PT34_Positioning operation data default (**PDEF)]

Initial value
00000000h
[Pr. PT34.0_Point table default]
Initial value
0h
0: Disabled
1: Enabled
When initializing the point table, set "1".
After setting [Pr. PT34.0] = "1" and [Pr. PT34.3 Default availability] = "5" (permitted), cycle the power or reset the software to
initialize the point table.
After the initialization is completed, the setting value of [Pr. PT34] is automatically set to "00000000h".
[Pr. PT34.3_Default availability]
Initial value
0h
0: Prohibited
5: Permitted
When initializing the point table, set "5".
After the initialization is completed, the setting value of [Pr. PT34] is automatically set to "00000000h".

[Pr. PT38_Function selection T-7 (**TOP7)]

Initial value
00000000h
[Pr. PT38.4_Limit switch release position assessment function selection]
Initial value
0h
Set the limit switch release position assessment function.
This function is enabled in the cyclic synchronous position mode or the cyclic synchronous speed mode.
Refer to the following table for the combinations available for the assessment function.
Setting value
0
1
1 SERVO PARAMETER DETAILS
164
1.9 Positioning control setting servo parameters group ([Pr. PT_ _ ])
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
Refer to the text
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Limit switch release position assessment function
Disabled
Enabled
Setting method
Each axis
Ver.
B8
Ver.
B8
Setting method
Each axis
Ver.
B2
Ver.
Refer to the relevant detail No.
Ver.
Refer to the relevant detail No.