Table of Contents
Advertisement
4.7.6.5
DC Power Page
When the DC Power tab is selected, the following web page opens. This page and its sub-menus
allow a user to operate the power supply and adjust its output settings.
A. DC Power ➔ Output Page
When the DC Power tab is selected, the Output page opens by default (GUI).
Figure 4–11: Output Page
Refresh List
When this button is clicked, the web page scans to find connected Multi-drop power supplies and
adds the discovered addresses into the list box. This button applies to a multi-drop chain only as
described in section 4.7.1.1.
Click the Refresh List button after clicking the DC power button, after connecting or disconnecting a
power supply, or after changing the RS-485 address.
Select RS-485 Multi-drop Address
This address is described in section 4.7.1.1. This address applies to a multi-drop chain of RS-485
supplies only. If there is no multi-drop chain, only the address of the single LAN supply is available.
Blink Identify
When this button is clicked, the Master (LAN) power supply Front Panel display and the rear panel
green LAN status LED blinks.
In a multi-drop chain, only the master (LAN) power supply blinks. The blink identification is turned
OFF by clicking this button again or by clicking any button or encoder on the power supply Front
Panel or by SCPI command. Login is not required to use this function.
Measurements
This section displays the selected power supply's actual output Voltage, Current, operating mode
(constant-voltage, constant-current, constant power or off). Faults are shown in the voltage and
current display.
70
Advertisement
Table of Contents
