Table of Contents
Advertisement
OUTPut:RELay2[:STATe] <Bool>
Function
Parameter
Query
Return
OUTPut:TTLTrg:MODE <DSC>
Function
Parameter
Query
Return
4.14.7
Program Subsystem
[PROGram]:COUNter <NR1> | INFinity
Function
Parameters
Query
Return
[PROGram]:LIST:CURRent <NRf+>,{<NRf+>}
Function
Parameters
Unit
Query
Return
Example
A delay of ~100mSec is required after the [PROGram]:LIST:CURRent command if long
sequences are used, prior sending any additional command.
Sets PROG_OUT_2 pin (J1-20) in a rear panel connector. 0 – MOSFET is ON.
1 – MOSFET is OFF.
0|1, OFF|ON
OUTPut:RELay2[:STATe]?
<Bool> 0|1
Sets the operation mode of the Trigger Out signal to OFF, FSTR, or TRIG
mode.
Programming Mode - NONE:
In TRIG mode, a trigger is generated if output state changes.
•
In FSTR mode, an output pulse is generated automatically any time an
•
output parameter, such as output state, voltage, or current is
programmed.
Programming Modes - LIST or WAVE:
•
In TRIG mode, a trigger is generated if LIST or WAVE has completed.
•
In FSTR mode, an output pulse is generated automatically any time a
step has completed.
0|1|2, OFF|FSTR|TRIG
OUTPut:TTLTrg:MODE?
<DSC> OFF|FSTR|TRIG
Sets the sequencers' iterations counter
1 ~ 9999. Any number greater than 9999 is interpreted as INFinity.
Use INFinity if you wish to execute a sequence indefinitely.
[PROGram]:COUNter? (if COUNter > 9999, the response is INF)
<NR1>| INF
Specifies the output current points in a list.
Current points are separated by commas.
The function accepts up to 100 parameters.
The range is limited by the power supply current programming range.
A
[PROGram]:LIST:CURRent?
<NR2>,{<NR2>} 5-digits format.
LIST:CURR 2.5,3.0,3.5; LIST:CURR MAX,2.5,MIN
NOTE
108
Advertisement
Table of Contents
