Wave Mode Example - TDK-Lambda GH10-100 User Manual

Start condition: Assume power supply output is on; Initial voltage point is 0 Volts.
Arbitrary waveforms can be easily created by using the Waveform Creator application available on
TDK-Lambda Web-Site. Refer to Quick Start Guide documentation on TDK-Lambda Web-Site.
5.3.5

WAVE Mode Example

VOLT:MODE WAVE
WAVE:VOLT 2,4,4,9,9,3,3
WAVE:TIME 1,0.5,0.5,0.5,0.5,1.5,1.5
STEP AUTO
COUN 1
TRIG:SOUR BUS
INIT:CONT OFF
INIT
*TRG
Start condition: Assume power supply output is on; Initial voltage point is 0 Volts.
Arbitrary waveforms can be easily created by using the Waveform Creator application available on
TDK-Lambda Web-Site. Refer to Quick Start Guide documentation on TDK-Lambda Web-Site.
NOTE
NOTE
Select Sequence Mode
Set voltage values "2,4,4,9,9,3,3" Volts
Set time values "1,0.5,0.5,0.5,0.5,1.5,1.5" Seconds
Set AUTO step execution mode "AUTO"
Set wave execution iterations "1"
Select BUS trigger source via communication
interface or front panel
Trigger system is enabled for a single trigger action
Trigger initialize
Trigger command
Figure 5–6: WAVE Mode Example
NOTE
NOTE
138