Slave Role Non-Volatile Memory Parameters - TDK-Lambda GH10-100 User Manual

5.9.10.2

Slave role non-volatile memory parameters

Refer to Table 5-4: Slave Role Non-Volatile Memory Parameters for the default non-volatile
memory parameters set when power supply changes its role to Slave.
Function
Power Supply Start Mode
Power Supply Output State
Voltage Set Point [V]
Current Set Point [A]
Over Voltage Protection (OVP) [V]
Under Voltage Level (UVL) [V]
Under Voltage Protection (UVP) Mode
Under Voltage Protection (UVP) Delay [S]
Fold-Back Mode
Fold-Back Delay [S]
Constant Power Function
Constant Power Set Point [W]
Slew Mode
Voltage Slew Up / Down [V/mS]
Current Slew Up / Down [A/mS]
Internal Resistance Function
Internal Resistance Set Point [Ω]
Voltage Reference Programming Source
Current Reference Programming Source
Analog Mode Current Limit (OCL)
Analog Programming & Monitoring Range [V]
Programmable Pin 1
Programmable Pin 2
Front Panel Remote Mode
Front Panel LOCK
Output Sense (LOC / REM)
Interlock (ILC) Function
Enable (ENA) Function
Enable (ENA) Polarity
Power Supply OK (PS_OK) Delay [S]
Preload
Communication Interface
Communication Power Supply Address
Communication Baud Rate [Baud]
Communication Language
LAN parameters
Special Voltage Upper Limit (SVUL)
Slave Role
SAFE
OFF
0
1.05 * RATED
1.1 * RATED or 1.2 * RATED (Model Dependent)
0
OFF
01.0
OFF
01.0
OFF
RATED VOLTAGE MULTIPLYED BY RATED CURRENT
OFF
999.99
SAME AS MASTER POWER SUPPLY
OFF
0.001
DIG
DIG
OFF
5
OFF
OFF
LOCAL
OFF
LOC
OFF
OFF
REV
00.01
SAME AS MASTER POWER SUPPLY
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting), except Host Name
RATED
150