Table of Contents
Advertisement
CHAPTER 4:
4.1
Introduction
This chapter describes the set-up, operation, commands, and communication protocols of the
power supplies via serial communication interfaces: RS232, RS485, or USB, and LAN.
4.2
Configuration
Function Level Display
Communication
Interface
Address
Baud Rate
Language
IP Address
MAC Address
LAN Reset
4.2.1
Default Setting
Refer to Table 2-6: Non-Volatile Memory Parameters and Table 2-7: LAN Non-Volatile Memory
Parameters for factory default settings.
4.2.2
Communication Interface Selection
The power supply communication interface can be set to RS232, RS485, USB, LAN, or OPT *.
5.
Press the COMM button.
COMM LED illuminates. INTFC message appears on the Voltage display.
6.
Rotate the Current encoder to select a required communication interface.
7.
Press the Current encoder to accept a parameter.
When the parameter is accepted, the display blinks once.
8.
To exit the menu, press the COMM button or the BACK button.
* OPT option is available only if an optional communication card (i.e. IEEE, MODBUS TCP or
EtherCAT) is installed.
SERIAL RS232/RS485, USB & LAN INTERFACES
Parameter Level
RS232
RS485
USB
INTFC
LAN
OPT
ADR
0...31
9600...115200
BAUd
SCPI
LANG
GEN
IP1...IP4
IP
MAC1...MAC6
MAC
RESET
LAN
Table 4-1: Front Panel Setup
Display
RS232
RS485
USB
LAN
OPT
0...31
9.6K...115.2K
SCPI
GEN
IP1...IP4
MAC1...MAC6
RESET
NOTE
48
Description
Available only if an optional
communication card is installed.
Advertisement
Table of Contents
