Software Control Method
Winterization can also be run using Evinrude
Diagnostics software. With the outboard running,
start the process at the Settings/Adjustments
screen and follow the instructions.
1. Winterization start button
After the outboard shuts itself off, turn key switch
OFF, then detach garden hose.
IMPORTANT:
When finished, leave the outboard
in vertical position long enough to completely drain
the powerhead.
Additional Recommendations
Failure to check for fuel leakage could allow a
leak to go undetected, resulting in fire or
explosion.
•
Fill oil reservoir.
•
Inspect the fuel filter. If there is debris in the fuel
filter, it must be replaced.
•
Replace gearcase lubricant.
•
Remove and inspect propeller.
•
Clean and grease propeller shaft.
•
Blow water from gearcase speedometer pickup
system (gearcase speedometer models only).
•
Lubricate all grease fittings and linkages.
1
•
Inspect outboard, steering system, and con-
trols. Replace all damaged and worn compo-
nents. Refer to manufacturer's and lubrication
recommendations.
008564
•
Touch up painted surfaces as needed. Coat
outer painted surfaces with automotive wax.
•
Remove battery(s) from boat. Store in a cool,
dry location. Periodically charge battery(s) while
stored. Refer to manufacturer's maintenance
recommendations when servicing batteries.
•
Store outboard in upright (vertical) position.
•
Check for fuel leakage.
008565
Routine Service
Storage
WARNING
2
51