BRP E-TEC EVINRUDE Manual page 23

SystemCheck Harness
Connections
NOTICE
BE SURE all harnesses and wires are not
pinched, cannot contact flywheel, and do not
interfere with moving throttle or shift link-
ages.
Place the wiring harness through notch in lower
motor cover and route to the recess in the fly-
wheel cover. Secure the cable with a tie strap as
shown:
1
1. Recess
2. Tie strap
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
1. Seal
2
002011
1
42079A
Outboard Rigging Connections
Arrange connectors in flywheel cover.
Install electrical cover and secure with screws.
I-Command Network Connections
NOTICE
To prevent wire chafing, harness must be
routed below the flywheel cover.
If the outboard will be used with I-Command, or
other NMEA 2000 compliant CANbus instruments,
use the following connections to supply informa-
tion to the network:
Remove lower motor covers. Remove air silencer.
Route I-Command Engine Interface Cable around
the front of the throttle body, following the path of
Routine Service
001999
002102
23
2