BRP E-TEC EVINRUDE Manual page 301

Use a punch to remove the upper pin.
Retract the tilt cylinder rod.
Remove the external snap rings from the lower
pin.
Use a punch to remove the lower pin and remove
the trim/tilt unit from the stern brackets.
Remove the unit from the stern brackets far
enough to remove the ground lead from the pump
motor mounting screw.
25065
1. Ground lead
Installation
2-Cylinder Models
Lubricate the cylinder and thrust rod bushings with
Triple-Guard grease. Install the bushings.
25077
Install the ground lead.
Place trim/tilt unit into position.
25076
Trim and Tilt
Trim and Tilt Replacement
1
002527
15591
12
301