BRP E-TEC EVINRUDE Manual page 257

and three upper screws and tighten to a torque of
60 to 84 in. lbs. (7 to 9.5 N·m).
1
1. Lower inner exhaust housing screws
1
1. Upper inner exhaust housing screws
Apply Adhesive 847 to the bottom flange of the
inner exhaust housing. Install a new seal. Apply
Triple-Guard grease to outer seal surface.
1
1. Seal
2. Bottom flange
Clean and degrease the adapter housing and
outer exhaust housing mating surfaces with
1
1
001974
1
1
001975
2
001973
Exhaust Housing, 3-Cylinder Models
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
Place the adapter/inner exhaust housing into the
exhaust housing. Guide the water tube through
the hole in the outer housing and the alignment
pin into the adapter housing.
1. Alignment pin
Apply Gasket Sealing Compound to threads of the
four retaining screws and tighten to a torque of 60
to 84 in. lbs. (7 to 9.5 N·m).
1
1. Adapter retaining screws
Midsection
001983
1
001980
11
1
001981
257