BRP E-TEC EVINRUDE Manual page 176

Oiling System
Oil Component Servicing
2-Cylinder Models
1
1. Screw
1. Screws
All Models
Disconnect the electrical connector to the oil injec-
tion pump and manifold assembly.
1
1. Oil pump connector
176
Disconnect the electrical connector to the low oil
switch.
008073
1. Low oil switch connector
IMPORTANT:
before proceeding with disassembly.
1
Remove oil distribution hoses from the manifold.
Installation
1
Position oil tank assembly on powerhead. Clean
mounting screws and apply Nut Lock to threads.
Install screws and tighten to a torque of 30 to 42
in. lbs. (3.5 to 5 N·m).
Install protective sleeves and route oil distribution
008074
hoses from the oil distribution manifold to the
crankcase oil delivery fittings. Refer to Oil Supply
Diagrams on p. 162. Secure oil hoses to crank-
case fittings with tie straps.
1. Tie strap
008075
Run outboard and check for leaks. Use Evinrude
Diagnostics software to activate "Oil Prime."
Check oil flow through oil distribution hoses.
Check oil system operation and routing of oil sys-
tem hoses.
1
Note oil distribution hose routings
1
008076
006573