BRP E-TEC EVINRUDE Manual page 227

•
Tighten the upper mount screws to a torque of
110 to 130 ft. lbs. (149 to 176 N·m). Make sure
that screw heads are tight against steering arm.
3
1
2
1. Large powerhead screws
2. Small powerhead screws
3. Upper mount screws
1. Rear small powerhead screw
Large screw torque sequence, 1–8
Small screw torque sequence, A–E
IMPORTANT:
screws after outboard has been run at full operat-
ing temperature and allowed to cool.
Apply Gasket Sealing Compound to exhaust relief
muffler gasket and retaining screws. Install muffler
and tighten screws to a torque of 60 to 84 in. lbs.
1
(7 to 9.5 N·m).
002153
Place the shift rod in the shift rod lever. Install the
retaining pin and washer. Tighten pin to a torque
of 60 to 84 in. lbs. (7 to 9.5 N·m).
1
002160
1. Shift rod screw
Check shift linkage adjustment. Refer to Shift
Linkage Installation on p. 220.
IMPORTANT:
solidly into both forward and reverse and that pro-
peller shaft spins freely in neutral.
002167
Powerhead
Powerhead Installation
Retighten powerhead mounting
1
Make sure the gearcase shifts
002163
10
002013
227