BRP E-TEC EVINRUDE Manual page 309

chart. Part number is stamped on the bottom of
the housing of trim and tilt assemblies.
1
1. Part number
Trim and Tilt
Assembly P/N
5007774,
5009035
5005756
5007776,
5008949
Place the shim on the piston.
1
1. Shim
008814
Shim
0.120 in. (3 mm)
0.060 in. (1.5 mm)
none
008830
Place the loading mandrel, on the piston. Make
sure the edge of the loading mandrel is flush with
the top edge of the seal groove in the piston.
1. Edge of the loading mandrel
2. Seal groove
If the edge of the loading mandrel is not flush with
the top of the seal groove, the wrong shim was
selected. Check shim selection and reinstall the
mandrel.
Lubricate the mandrel with trim/tilt fluid.
Use a piece of wire to suspend the seal in a cup of
hot water. Warm the seal in hot water for about
one minute.
Trim and Tilt
Trim and Tilt Service
2
1
008831
008832
309
12