BRP E-TEC EVINRUDE Manual page 27

Outboard
Model
40–90 HP 640 CCA (800 MCA) or
800 CCA (1000 MCA) below
32° F (0° C)
Battery Location
Proper installation will prevent battery movement
while underway.
•
Secure all batteries in protected locations
•
Place battery as close to the outboard as possi-
ble
•
Battery location must provide access for peri-
odic maintenance
•
Use battery mounting trays or battery boxes on
all battery installations
•
Connections and terminals must be covered
with an insulator
•
Battery connections must be clean and free
from corrosion
•
Read and understand the safety information
supplied with the battery before installation.
Battery Connections
WARNING
Keep the battery connections clean, tight, and
insulated to prevent their shorting or arcing
and causing an explosion. If the battery
mounting system does not cover the connec-
tions, install protective covers. Check often to
see that connections stay clean and tight.
Check battery connections frequently. Periodically
remove battery to clean and service connections.
•
Confirm that battery meets the minimum engine
requirements.
•
Connections must be clean and tight.
•
Observe all wiring connections prior to disas-
sembly.
Disconnecting the Battery
Disconnect battery negative (–) cable first and the
battery positive (+) cable last.
Clean all terminals, battery posts, and connectors
with a solution of baking soda and water. Use a
wire brush or battery terminal tool to remove cor-
rosion buildup. Rinse and clean all surfaces.
Battery Rating
Battery and Battery Connections
Connecting the Battery
NOTICE
Do not use wing nuts to fasten ANY battery
cables. Wing nuts can loosen and cause elec-
trical system damage not covered under war-
ranty.
IMPORTANT:
Connect the battery positive (+)
cable to the battery positive (+) post FIRST. Con-
nect the battery negative (–) cable to the battery
negative (–) post LAST.
Install a star-washer on the threaded battery post.
Stack cables from the outboard, then cables from
accessories. Finish this connection with a hex nut.
1
Marine Style Battery Post
1. Starwasher
2. Hex nut
3. Terminal Insulator
Tighten all connections securely. Apply Triple-
Guard grease to prevent corrosion.
Routine Service
3
2
DR5103
27
2