BRP E-TEC EVINRUDE Manual page 153

Remove fuel injector and insulator.
Clean up any spilled fuel with shop towels.
ENVIRONMENTAL NOTE
Dispose of fuel contaminated towels in an envi-
ronmentally responsible manner, or according to
local regulations.
Crush Ring Replacement
NOTICE
Injector crush rings must be replaced if injec-
tor is installed in a different head or cylinder
location.
Use Injector Puller Kit, P/N 356461, to remove
injector from mounting cup.
Turn the nut of the fuel injector puller counter–
clockwise several turns. Place the fuel injector
puller on the fuel injector housing.
1. Puller nut
2. Fuel injector housing
1
2
008795
Fuel Component Servicing
Align the angled edges of both sides of the tool
base with the edge of the fuel injector housing as
shown.
1. Angled edge of the tool base
Thread the puller screw into the fuel injector 1/4-
20 threaded hole until it seats.
1. 1/4-20 threaded hole
Turn puller nut clockwise until it contacts the puller
base.
Use a 1/2 inch (13 mm) wrench to continue turn-
ing the puller nut clockwise.
Fuel System
1
008796
008797
1
008798
153
7