BRP E-TEC EVINRUDE Manual page 321

Place the friction plate spring washer between the
two friction plates on the pulley hub. Secure the
friction plate and friction plate spring washer with
the pulley lock ring.
1
1. Friction plate spring washer
2. Friction plates
Make sure the starter pawl bushing is installed in
the pulley. Apply Triple-Guard grease or Lubriplate
777 to boss of the starter pawl. Place spring
washer on the boss of the starter pawl. Place the
starter pawl in the pulley.
Place the starter housing spring in the starter
housing.
1
1. Lock ring
2. Spring washer (under starter pawl)
3. Spring
Install the starter pawl plate return spring on the
starter pawl plate. Press the other end of spring
2
2
34854
2
3
COA1361
Recoil Starter Assembly
on the boss of the pulley. Position the starter pawl
plate on the pulley.
2
1. Spring
2. Plate
Clean threads of the starter pawl plate retaining
screw and nut to remove adhesive.
Install the starter pawl plate retaining screw and
washer into the starter housing. Tighten screw to
a torque of 96 to 120 in. lbs. (11 to 13.5 N·m).
1
1. Screw
Spray threads of starter pawl plate retaining screw
and nut with Locquic Primer. Apply Nut Lock to the
threads of the nut. Install and tighten the nut
securely.
Manual Starter
1
46767
COA1375
13
321