BRP E-TEC EVINRUDE Manual page 270

Midsection
Stern Bracket, 2-Cylinder Manual Tilt
Install and tighten the nut to a torque of 144 to 168
in. lbs. (16 to 19 N·m).
1
1. Port stop link screw
2. Wave washer
Install the smaller shoulder screw through the
starboard stop link and stern bracket. Install and
tighten the nut to a torque of 144 to 168 in. lbs. (16
to 19 N·m).
Apply Ultra Lock to threads of large setscrews.
Install the screws in the swivel bracket so that one
thread remains outside the casting.
1. Setscrews
270
2
COA2984
1
1
COA2961
Place the steering friction bushing in the swivel
bracket with groove in line with the setscrews.
Apply Triple-Guard grease to the steering friction
pin. Install the pin in the swivel bracket flush with
inside surface. The pin should point up.
1. Steering friction pin
Install the steering friction thrust ring, bevel side
up, in the swivel bracket. Thread the steering fric-
tion screw in the swivel bracket. Turn the screw
until the steering friction pin makes contact with
top of the thrust ring. Do not tighten the screw.
1. Steering friction thrust ring
COA2986
1
COA2988
1
COA2987